Metalshield® Zinc Galv Spray
About Metalshield® Zinc Galv Spray
Dulux Metalshield® Zinc Galv spray is a superior anti-corrosive coating for protection against rust and corrosion. Its zinc-rich formulation forms a sacrificial barrier against corrosion.
Downloads
Application
At a glance
- Highly effective barrier against moisture
- Ideal for steel, wrought iron, welds and repairing damaged galvanised iron
- Available in 400g
- Available in Grey base
- Superior anti-corrosive coating for metal protection
Areas to use
Performance guide
Typical areas of application inlcuding coating wrought iron fences, hinges and outdoor furniture and repairing damaged galvanised iron.
Surfaces
• Steel
• Wrought iron
• Galvanised steel
• Metal
Previously Painted Surfaces
Do not apply on top of existing painted surfaces.
Unpainted Surfaces
Ensure the surface has thoroughly dried prior to application.
Do not apply on top of existing painted surfaces.
Aged/lightly rusted surfaces:
• Remove any rust by scraping, sanding or wire brushing.
• Wipe surface with Dulux Metalshield® Brush Thinner to remove any residual grease, oils and dirt.
New bare steel, wrought iron:
• Wipe surface with Dulux Metalshield® Brush Thinner to remove any residual grease, oils and dirt.
Galvanised iron:
• Clean surface with Selleys® Sugar Soap and a Scotch-Brite® Pad to remove any grease, oils and dirt.
• Rinse with clean water.
Do not apply on top of existing painted surfaces.
Brush, roller
Before spraying
• Shake can for at least three minutes after first rattle and regularly during use.
• Lower temperatures and high humidity will slow the drying and affect the gloss level.
• Avoid spraying when air or surface temperature is below 10°C or above 30°C.
Spray application
• Hold can upright 15 to 25cm from the surface.
• To ensure surface compatibility, test spray on an inconspicuous area.
• Spray with smooth, even strokes parallel to the surface.
• Apply with several light mist coats rather than one heavy coat, which can cause running and sagging.
After spraying
• Prevent blocking by turning the can upside down and spraying until clear gas emerges.
• Also wipe front of nozzle clean.
• Clean up overspray while it is still wet with mineral turpentine.
Unused paint
Storage
• Store in a cool, dry, well-ventilated place and and away from oxidising agents and corrosive materials.
• Protect from sunlight.
• Store away from sources of heat and/or ignition.
• Do not expose to temperatures exceeding 50°C.
Unused paint
Spray unwanted paint onto newspaper and allow to dry, and then disposed of via domestic waste collections.
Disposal of empty aerosol containers via domestic recycling programs differ between local authorities.
For more information on responsible disposal of paint and packaging visit painttakeback.co.nz or paintback.com.au.
Empty paint containers
Empty paint containers:
Empty aerosol cans are recyclable via steel can recycling programs.
Disposal of empty aerosol containers via domestic recycling programs differ between local authorities.
Check with your local council first.
For more information on responsible disposal of paint and packaging visit painttakeback.co.nz or paintback.com.au.
