Metalshield® Hammered Finish Spray Paint
About Metalshield® Hammered Finish Spray Paint
Dulux Metalshield® Hammered Finish is a durable, protective finish that can be applied to a wide range of metal and pre-painted surfaces including steel, wrought iron, galvanised iron, Zincalume, stainless steel, aluminium, brass, copper and timber. The hammered-effect finish is ideal for hiding surface imperfections such as scratches and weld joints. Use it on machinery, trailers, fences, railings, gates, windows, downpipes, doors and furniture. Available in four colours: Blue, Bronze, Charcoal and Silver.
Application
At a glance
- Suits wide range of surfaces
- Durable protective finish
- Suits wide range of metal surfaces
- Available in 300g
- Ideal for hiding dents and scratches
- Available in four colours: Blue, Bronze, Charcoal and Silver
- Ideal for hiding dents and scratches
Areas to use
Surfaces
• Steel
• Wrought iron
• Aluminium
• Brass copper
• Pre-painted surfaces
• Timber
• Most plastic
• Aged/lightly rusted surfaces
• New bare steel
• Galvanised iron
• ZINCALUME®
• Stainless steel
Previously Painted Surfaces
Aged/Lightly rusted metal surfaces:
• Remove any rust by scraping, sanding or wire brushing.
• Wipe surface with Metalshield Brush Thinner to remove any residual grease, oils and dirt.
New Bare Steel and Wrought Iron:
• Wipe surface with Metalshield Brush Thinner to remove any residual grease, oils and dirt.
Galvanised Iron, ZINCALUME®:
• Clean surface with Selleys® Sugar Soap and a Scotch-Brite® Pad to remove any grease, oils and dirt. Rinse with clean water.
Aluminium, Copper, Brass, Stainless Steel:
• Clean surface with Selleys Sugar Soap and a Scotch-Brite Pad to remove any grease, oils and dirt.
• Rinse with clean water.
Brush, roller
Before Spraying:
• Shake can well for at least 2 minutes after the ball starts rattling and regularly during use.
• Lower temperatures and high humidity will slow the drying and affect the gloss level.
• Avoid spraying when air or surface temperature is below 10°C or above 30°C.
During Spraying:
• Hold the can upright 10 to 25cm from the surface.
• To ensure surface compatibility, test spray on inconspicuous area.
• Spray with smooth even strokes, parallel to the surface.
• Apply several light mist coats rather than one heavy coat, which can cause runs and sags.
After Spraying:
• Prevent blocking by turning the can upside down and spraying until clear gas emerges.
• Also wipe front of nozzle clean.
• Clean up overspray while it is still wet with mineral turpentine.
Unused paint
Storage
• Store in a cool, dry, well-ventilated place and and away from oxidising agents and corrosive materials.
• Protect from sunlight.
• Store away from sources of heat and/or ignition.
• Do not expose to temperatures exceeding 50°C.
Unused paint
Spray unwanted paint onto newspaper and allow to dry, and then disposed of via domestic waste collections.
Disposal of empty aerosol containers via domestic recycling programs differ between local authorities.
For more information on responsible disposal of paint and packaging visit painttakeback.co.nz or paintback.com.au.
Empty paint containers
Empty paint containers:
Empty aerosol cans are recyclable via steel can recycling programs.
Disposal of empty aerosol containers via domestic recycling programs differ between local authorities.
Check with your local council first.
For more information on responsible disposal of paint and packaging visit painttakeback.co.nz or paintback.com.au.
