Concrete & Paving Coloured Sealer Satin

White Tint: Sealed Surfaces. 

Medium & Maximum Tint: Bare Concrete

Bare concrete and Sealed surfaces once appropriate preparation has been completed using the Dulux Concrete & Paving Stage 1 and 2 products.

1. Stir well before and during application with a broad, flat paddle using an up and down scooping action.   

2. Use a brush to apply to any edges and hard-to-reach places.  

3. Use a roller to apply 1st coat evenly across the surface. 

4. Work in small sections, slightly overlap the previous section to minimize raised edges.  

5. Gently go over the surface in the same direction with an unloaded roller using minimal pressure to give a smooth consistent finish. 

6. Allow to fully dry before applying the 2nd coat. 

Do not pour leftover paint down the drain. 

Unwanted paint should be brushed out on newspaper and allowed to dry, and then disposed of via domestic waste collections. 

For more information on responsible disposal of paint and packaging visit painttakeback.co.nz or paintback.com.au.

Leave empty paint containers open in a well-ventilated area to dry out. When dry, recycle the container via steel can recycling programs.

Disposal of empty paint containers via domestic recycling programs may differ between local authorities. Check with your local council first. 

Do not reuse container unless thoroughly decontaminated. 

For more information on responsible disposal of paint and packaging visit paintback.com.au or painttakeback.co.nz