Design Stainless Steel Effect

• Plasterboard 

• Brick 

• Cement sheet

• Bare timber

• Set plaster 

• Fibrous plaster

• Metal surfaces

• Dulux Stainless Steel Effect can be applied over previously painted surfaces that are in good condition. 

• For optimum appearance a perfectly smooth surface free of defects is required. 

• Differences in surface gloss or variations in surface porosity can result in uneven colour and patchy appearance. 

Previously painted surfaces in good condition: 

• Dust, then clean with Selleys® Sugar Soap. 

Previously painted surfaces with cracks or holes repaired with filler: 

• Spot prime repairs with Dulux Prepcoat Acrylic Sealer Undercoat. 

Glossy surfaces: 

• Lightly sand to a dull finish. 

• For optimum appearance a perfectly smooth surface free of defects is required. 

• Differences in surface gloss or variations in surface porosity can result in uneven colour and patchy appearance. 

Unpainted plasterboard, brick, cement sheet, bare timber: 

• Apply one coat of Dulux Acrylic Sealer Undercoat. 

Unpainted set plaster, fibrous plaster, plasterglass: 

• Apply one coat of Dulux PRECISION® Sealer Binder. 

Unpainted metal surfaces: 

• Thoroughly degrease and apply Dulux PRECISION® All Metal Primer.

• Stir thoroughly prior to use. 

• Before you begin, test your chosen application method on a large piece of board. 

• Mask off adjacent walls, skirting boards and cornices. 

• Brush around the edges of the wall. 

• Apply the first and second coat with a short nap roller using light, even pressure. 

• Take the roller as close to the edge to cover the brush marks. 

• Working in small sections, apply the third coat with a roller. 

• While the paint is still wet, drag the brush in a random pattern. 

• Best results are achieved by lightly brushing in one direction or reworking paint to achieve a brushed stainless steel effect. 

• Make sure to overlap brushed areas to achieve an even effect. 

• Avoid touching up. 

Spraying: 

• On broad wall areas application by spray is recommended as this will give a more authentic look.

• Thin with 5% water if required. 

• Apply three to four thin coats to achieve the desired effect and coverage. 

Thinning: 

• Recommended for spraying only. Thin with 5% water.

Do not pour leftover paint down the drain. 

Unwanted paint should be brushed out on newspaper and allowed to dry, and then disposed of via domestic waste collections. 

For more information on responsible disposal of paint and packaging visit painttakeback.co.nz or paintback.com.au.

Leave empty paint containers open in a well-ventilated area to dry out. When dry, recycle the container via steel can recycling programs.

Disposal of empty paint containers via domestic recycling programs may differ between local authorities. Check with your local council first. 

Do not reuse container unless thoroughly decontaminated. 

For more information on responsible disposal of paint and packaging visit paintback.com.au or painttakeback.co.nz