DULUX Luxaprime® Zinc Phosphate - PC612
Code:
866-LINE
Approvals:
AS3750.19 Type 2; Standard Red is approved to APAS 2921 and APAS 0032; Approved to AS 2910 with Ferrodor 810 topcoat; Approved to APAS 2940 with Ferrodor F topcoat.
Luxaprime® Zinc Phosphate is a single pack zinc phosphate primer offering good corrosion protection over power tool cleaned steel. The high build formulation allows higher film builds in fewer coats.
Features
- Available in Red, Light Grey and Blue
- Zinc phosphate pigmentation
- Single pack, easy to use
- Easy to apply by brush, roller, conventional or airless spray
- Good adhesion and performance on power-tool cleaned steel
Performance Guide
| Weatherability | Some chalking will occur on exterior exposure if not topcoated. This will not detract from the protective properties of the coating. |
| Heat Resistance | Up to 120°C dry heat. |
| Water Resistance | Resists condensation and rain. Not suitable for permanently damp conditions or immersion. |
| Abrasion Resistance | Good abrasion resistance when fully cured. |
| Solvent Resistance | Withstands intermittent splash and spillage of aliphatic and aromatic hydrocarbons. |
| Acid Resistance | Not recommended where fumes, splash or spillage may occur. |
| Alkaline Resistance | Not recommended where fumes, splash or spillage may occur |
| Salt Resistance | Excellent resistance to splash ans spillage of neutral salt solutions. |
Application
Roller, Brush, Airspray, Conventional Spray
Surface Preparation
Round off all rough welds and sharp edges, and remove weld spatter. Degrease by detergent wash according to AS1627.1. For all structural and decorative steel, abrasive blast clean to AS1627.4 Class 2.5. Remove all dust. Apply first coat before surface deterioration occurs.
Uses
Luxaprime® Zinc Phosphate is typically used as a primer under suitable topcoats on cranes, tanks and roofs,and as a primer/finish in internal steelwork in warehouses and factories.
Sizes
4L and 15L cans
Bases
Standard Red, Light Grey, Blue
Use and typical specification
[Steel]: Power tool clean to AS1627.2 St 3. Typical system: 1 x Luxaprime® ZP @ 75 microns + 2 x Duraflex® 2 @ 50 microns.