DULUX Duremax® GPE Zinc Phosphate - PC215
AS3750.19 Type 2; Standard Red is approved to APAS 2921 and APAS 0032. Approved to AS 2910 with Ferrodor 810 topcoat.
Duremax® GPE ZP is a two-pack epoxy steel primer formulated with zinc phosphate to offer active inhibitive protection to the steel against corrosion. The epoxy resin provides high strength adhesion to the substrate as well as excellent cohesion, binding the pigments together tightly to form a tough barrier offering additional passive barrier protection.
- Easy to apply by brush, roller, conventional or airless spray
- Zinc phosphate pigmentation
- High build formulation
- Good abrasion resistance
- Compatible with a wide range of primers
- Can be topcoated with a wide range of coating types.
- Good corrosion protection
- Excellent adhesion to most substrates
- High build formula provides superior protection at edges
|Weatherability||Some chalking and yellowing may occur on exterior exposure if not topcoated with a suitable UV resistant coating.|
|Heat Resistance||Up to 120°C dry heat.|
|Water Resistance||Excellent resistance to fresh and salt water. Excellent resistance to immersion when suitably topcoated.|
|Abrasion Resistance||Good abrasion resistance when fully cured.|
|Solvent Resistance||Resists splash and spillage of most hydrocarbon solvents, refined petroleum products and most common alcohols.|
|Acid Resistance||Suitable for splash and spillage of mild acids.|
|Alkaline Resistance||Good resistance to splash and spillage of strong alkali.|
|Salt Resistance||Excellent resistance to neutral and alkaline salt solutions.|
Roller, Brush, Airspray, Conventional Spray
Round off all rough welds and sharp edges, and remove weld spatter. Degrease by detergent wash according to AS1627.1. For all structural and decorative steel, abrasive blast clean to AS1627.4 Class 2.5. Remove all dust. Apply first coat before surface deterioration occurs.
Duremax® GPE ZP is suitable for the protection of structures exposed to moderate to severe environments such as chemical plants, refineries, ship loaders, coal wash plants and manufacturing facilities. Duremax® GPE ZP is also suitable for fresh and salt-water immersion when suitably topcoated.
4L and 15L packs
Use and typical specification
Mild steel: Abrasive blast AS1627.4 Class 2.5. Typical system: 1 x Duremax® GPE ZP @ 125 microns + 1 x Weathermax® HBR @100 microns.