DULUX Luxafloor® RollCoat - PC227

Code: 707-LINE

Dulux® Luxafloor® RollCoat™ is a two-pack, high solids epoxy floor coating, with significantly lower odour than conventional epoxies. Luxafloor® RollCoat™ has excellent flow-out on application, and therefore greatly improves the aesthetic appeal of concrete floors.

Features

  • Lower VOC and odour compared with conventional epoxies (<140 g/l when mixed)
  • Easy to apply by brush, roller, conventional or airless spray
  • Smooth, gloss finish with optional Luxafloor® Aggregate for added slip resistance where desired
  • Available in a standard range of factory packaged colours and tinted pastel colours

Benefits

  • Extremely tough and hardwearing

Performance Guide

WeatherabilitySome chalking and yellowing may occur on exterior exposure if not topcoated with a suitable UV resistant coating
Heat ResistanceUp to 120°C dry heat.
Water ResistanceExcellent resistance to fresh and salt water. Not suitable for immersion.
Abrasion ResistanceExcellent abrasion resistance when fully cured. CS-17 wheels 133 mg/1000 cycles (Taber Abrasion @ 1000g load/wheel)
Solvent ResistanceResists splash and spillage of aromatic and aliphatic hydrocarbon solvents and most common alcohols.
Acid ResistanceSuitable for splash and spillage of dilute acids.
Alkaline ResistanceExcellent resistance to splash and spillage of most alkalis.
Salt ResistanceExcellent resistance to neutral and alkaline salt solutions.

Application

Roller, Brush, Airspray, Conventional Spray

Surface Preparation

Degrease if necessary. Diamond grind or shot blast the floor to remove laitance and create a sound, profiled substrate. Areas inaccessible to diamond grinder or shot blast equipment shall be ground to a matching profile with power tools. Remove all dust and debris. Fill or patch holes and make flush with surrounding concrete. Ensure moisture content is below 10%.

Uses

Luxafloor® RollCoat™ is suitable for all flooring projects requiring a hardwearing surface. The extensive colour range makes Luxafloor® RollCoat™ suitable for use in internal floor areas such as car parks, garages and warehouses.

Sizes

10L packs

Bases

Factory packaged colours and mid base

Use and typical specification

Concrete: Detergent wash if necessary to remove oily deposits. Diamond grind to remove surface imperfections and laitance and provide a good key for the coating system. Typical system: 2 x Luxafloor® RollCoat™ @ 125 microns per coat.

Product downloads

Product Data Sheet - pdfMaterial Safety Data Sheet

Related products

Top of the page