INTERGRAIN Enviropro Endure 2 Pack

Code: 701-line

Extremely durable, user friendly, clear water based polyurethane timber floor finish that uses cross linking technology to produce a tough commercial grade finish.

Features

  • Water based
  • Low odour
  • Quick drying
  • Non-Yellowing

Benefits

  • Extremely Durable
  • Multiple Coats can be applied in one day
  • Clean application equipment with water

Performance Guide

Gloss level IndicatorMatt 15-20%, Satin 30-40%, Gloss >80%
VOC Properties<185 g/L
WeatherabilityInterior use only.
Heat ResistanceUp to 60C.
Water ResistanceGood for splashes and spillage
Abrasion ResistanceExcellent
Solvent ResistanceGood for weak solutions
Acid ResistanceGood for weak solutions
Alkali ResistanceGood for weak solutions
Salt ResistanceGood.

Application

Roller

Surface Preparation

All surfaces must be clean, dry, free of wax, grease, dust and other contaminants. The presence of contaminants increases the possibility of rejection and delamination. If uneven, the surface should be sanded with coarse sandpaper. All nail holes and cracks should be filled with Intergrain Woodblend putty. Fine sand the floor, finishing with 100 grit sandpaper, then with 150 mesh screenback and vacuum thoroughly with the commercial grade vacuum cleaner. Mix Endure 2 Pack Part A and Endure 2 Pack Part B at a ratio of 9 to 1 and shake for two minutes. Strain product.New Timber: Where a sealer is required, apply 1 coat of Enviropro Timberseal following the instructions on the Timberseal label. Lightly sand the sealer with a worn 150 mesh screen if needed. Apply 2 coats of Endure 2 Pack at 8-10m²/L using a 11mm Selleys Spirit micro-fibre roller. To improve adhesion and minimise grain raise, screen between coats with a worn 150 grit screen or 180 grit screen. Recoating Timber: To ensure adhesion, a test patch is recommended after the surface has been prepared. Wash the floor with Envriopro Squeaky Clean as per the label instructions. Sand with 100 grit screen then vacuum thoroughly and tack clean with damp rags. Apply 1 coat of Endure 2 Pack at 8-10m²/L using a 11mm Selleys Spirit micro-fibre roller. Note: For new and recoating timber, any contaminants that appear between coats will cause inconsistencies in the final film. For the final coat, it is recommended to seal doors, fireplaces and windows. To increase the wear resistance, apply up to 3 coats of Endure 2 Pack. On porous timbers, up to 3 coats of Endure 2 pack can also be applied to maximise the uniformity of the finish.

Clean Up

Water

Uses

Use on timber and parquetry floors.

Sizes

5L (PartA-4.5L, PartB-500mL)

Bases

Satin, Gloss & Matt

Use and typical specification

Intergrain Enviropro Endure 2 Pack is an extremely durable, non-yellowing water based coating for use on timber and parquetry floors. Endure 2 pack uses cross-linking technology to produce a tough commercial grade finish. Endure 2 pack is available in gloss, satin and matt.

Product downloads

Product Data Sheet - pdfMaterial Safety Data Sheet

Related products

Top of the page