INTERGRAIN Enviropro Endure 1 Pack

Code: 701-line

Highly durable, user friendly, clear water based polyurethane timber floor finish.


  • Water based
  • Low odour
  • Quick drying
  • Non-Yellowing


  • Highly Durable
  • Multiple Coats can be applied in one day
  • Clean application equipment with water

Performance Guide

Gloss level IndicatorMatt 15-20%, Satin 30-40%, Gloss >80%
VOC Properties<90 g/L
WeatherabilityInterior use only.
Heat ResistanceUp to 60C.
Water ResistanceGood for splashes and spillage.
Abrasion ResistanceVery good.
Solvent ResistanceGood for weak solutions.
Acid ResistanceGood for weak solutions.
Alkali ResistanceGood for weak solutions.
Salt ResistanceGood.



Surface Preparation

All surfaces must be clean, dry, free of wax, grease, dust and other contaminants. The presence of contaminants increases the possibility of rejection and delamination. If uneven, the surface should be sanded with coarse sandpaper. All nail holes and cracks should be filled with Intergrain Woodblend putty. Fine sand the floor, finishing with 100 grit sandpaper, then with 150 mesh screenback and vacuum thoroughly with a commercial grade vacuum cleaner. Shake the Endure 1 Pack for 1 minute or until any settled matting agent is reincorporated. Strain product. New Timber: Where a sealer is required, apply 1 coat of Enviropro Timberseal following the instructions on the Timberseal label. Lightly sand the sealer with a worn 150 mesh screen if needed. Apply 2 coats of Endure 1 Pack at 8-10m²/L using a 11mm Selleys Spirit micro-fibre roller. To improve adhesion and minimise grain raise, screen between coats with a worn 150 grit screen or 180 grit screen. Recoating Timber: To ensure adhesion, a test patch is recommended after the surface has been prepared. Wash the floor with Enviropro Squeaky Clean as per the label instructions. Sand with 100 grit screen then vacuum thoroughly and tack clean with a damp rag. Apply 1 coat of Endure 1 Pack at 8 - 10m²/L using a 11mm Selleys Spirit micro-fibre roller. For new and existing timber, any contaminants that appear between coats will cause inconsistencies in the final film. It is recommended to seal doors, fireplaces and windows. To increase the wear resistance, apply up to 3 coats of Endure 1 Pack. On porous timbers, up to 3 coats of Endure 1 pack can also be applied to maximise the uniformity of the finish.

Clean Up



Use on timber and parquetry floors.




Satin, Gloss & Matt

Use and typical specification

Intergrain Enviropro Endure 1 Pack is a high performance, environmentally responsible, water based polyurethane for timber and parquetry floors. Endure 1 Pack systems are highly durable and are the product of choice for floors that require a high quality. Endure 1 Pack has the added features of being low odour, quick drying and non-yellowing.

Product downloads

Product Data Sheet - pdfMaterial Safety Data Sheet

Related products

Top of the page