DULUX Texture Medium Cover

Code: 195-85715

A flexible acrylic texture applied directly from the bucket by mitt application. A range of effects can be easily achieved by finishing with a lambswool hand mitt applicator, sponge, brush or broom. This traditional bagging texture is used to create a coloured mottled appearance over brickwork, diffusing, but not completely hiding the brick pattern. It can also be used to create a textured effect over smooth masonry surfaces. Click here for steps on how to apply this product

Features

  • Bagged render finish
  • Achieve multiple effects
  • Hand mitt applied
  • Water based

Benefits

  • Same day recoat and clean up
  • Proven durability at high film builds
  • Achieves texture finish without special training
  • Low cost alternative to traditional rendering and texturing methods

Performance Guide

Gloss Level Indicator3
VOC Properties< 60g/L untinted
WeatherabilityExcellent resistance to weathering with minimal colour change and dirt pick up.
Heat ResistanceSoftens and suffers from dirt pick up over 70 degrees.
Water ResistanceResists prolonged rain and condensation.
Abrasion ResistanceGood resistance to abrasion.
Solvent ResistanceSensitive to aromatic hydrocarbons and alcohols.

Application

Lambswool hand mitt applicator

Coverage - 3 square metres per L

Surface Preparation

All surfaces must be thoroughly cleaned and free of all dirt, loose and flaking paint. Efflorescence or mould must be treated before application of paint. New concrete, mortar or cement render must be allowed to cure for 4 to 8 weeks depending on concrete thickness and drying conditions. Fill holes with grouting cement. Wash down with water using a stiff brush to remove all loose material. To test the adhesion of previously painted surfaces, cut an 'X' through the existing paint with a sharp blade, press cellulose tape firmly across the cut and then rip the tape off. If the old paint or render comes off, it should be removed. On porous surfaces, applying a priming coat thinned with water (4 parts Medium Texture: 1 part water) will condition the surface and help aid application of additional coats.

Clean Up

Clean all equipment with water

Uses

Application to bricks, cement render, fibre cement and masonry surfaces.

Sizes

4L, 10L

Bases

Can be tinted to a wide range of pastel and medium depth colours.

Use and typical specification

A flexible acrylic texture applied directly from the bucket by mitt application. A range of effects can be easily achieved by finishing with a lambswool hand mitt applicator, sponge, brush or broom. This traditional bagging texture is used to create a coloured mottled appearance over brickwork, diffusing, but not completely hiding the brick pattern. It can also be used to create a textured effect over smooth masonry surfaces.

Product downloads

Product Data Sheet - pdfMaterial Safety Data Sheet

Related products

Top of the page
Top of the page