DULUX Roof & Trim Semi Gloss
Dulux Roof & Trim is a high opacity, high performance 100% acrylic paint for all types of exterior roofs including galvanised iron, Colorbond®, ColorSteel® and trims such as plastic spouting, timber fascias, masonry and structural metals. Dulux Roof & Trim is specially formulated to enable safe collection of drinking water and to match the semi gloss sheen level and colours of Colorbond.
- Water based
- 100% acrylic paint
- Factory packaged colours
- 15 year guarantee*
- UV Protection
- Safe for the collection of drinking water^
- High performance colour durability
- Resists dirt and stains
- Easy to apply and washes up in water
Roller, Brush, Airspray, Con-Spray
Coverage - 16 square metres per L
For Colorbond® or ColorSteel® (NZ) pre-painted steel wash down roof with high-pressure hose and allow to dry. For bare galvanised iron and Zincalume® wash down roof with high-pressure hose and allow to dry. Apply 1 coat Dulux Prepcoat® All Metal Primer. For any rusted areas, remove rust with a suitable rust remover. Spot prime cleaned areas with Dulux All Metal Primer. For concrete tiles refer to Dulux Customer Service on 13 25 25 (AU) or 0800 800 424 (NZ) or for surface preparation details. For timber fascias including pre-primed timber ensure surface is sound for painting. Sand all dressed timber. Apply 1 coat of Dulux 1 Step® Acrylic Primer, Sealer & Undercoat. For steel/wrought Iron remove all rust by scraping, sanding or wire brushing and apply 2 coats of Dulux Prepcoat® All Metal Primer. For brick, masonry, fibro and fibre cement board fill holes with grouting cement. Wash down with water using a stiff brush to remove all loose material. Wash with a bleach solution and/or demossing chemical to remove mould or moss. Then hose down. For plastic spouting and downpipes sand all surfaces and dust off.
Clean all equipment with water
All exterior roofs, structural metals and fascias, plastic spouting, downpipes, timber, brick & masonry
7 popular Colorbond colours in a semi gloss sheen level
^ WATER COLLECTION
Where a roof is used for the collection of water
it is necessary to disconnect the tank inlets and
thoroughly hose down the surface to ensure
that active surfactants are washed away. Once
complete reconnect the tank inlets. Do not collect
drinking water within 48 hours after painting to
allow coating to fully dry.
*15 YEAR GUARANTEE Dulux guarantees that Roof & Trim will not PEEL, FLAKE or BLISTER for 15 years on metal roofs, timber and masonry, provided it is applied on
properly prepared surfaces as per the label directions. This guarantee does not cover paint failure caused by any breakdown of coatings applied previously or when used on
concrete tiles and plastics. If Dulux Roof & Trim does not perform as specified above, Dulux will provide free of charge paint to rectify the affected areas.
The warranty above applies for 15 years from the date of purchase. If the product does not perform as specified, we will replace the goods free of charge. To make a claim
under the warranty, please contact Dulux using the details shown and provide details of your claim. You must show proof of purchase and bear all expenses incurred in making
a claim. The benefits of this warranty are in addition to other rights and remedies under any applicable law. In Australia - Our goods come with guarantees that cannot be
excluded under the Australian Consumer Law. You are entitled to a replacement or refund for a major failure and compensation for any other reasonably foreseeable loss or
damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure.