DULUX AcraTex 400/4 Tiltwash
DULUX AcraTex 400/4 Tilt Wash is a water based low toxicity cleaning solution specifically designed to remove form oils & bond-breakers from concrete panels. To be used prior to the application of a paint/texture system
- Water based
- Removes Bondbreakers
- Spray application
- Fast removal of bondbreakers
- Easy application, clean up
- Cleans and conditions the concrete removing any stubborn contaminates.
- May be applied by airless spray which greatly reduces time on site.
- Uses only approximately 1/5 of water vs high pressure water blaster method
Low pressure spray, Airspray
Relative to Project Substrate and Specified Finish - refer to Project Specific Duspec Specification and AcraTex Substrate Guide
Use and typical specification
DULUX AcraTex 400/4 Tilt Wash is designed to be applied over Tilit Up or Off Form concrete panels to remove bondbreaker or release agents prior to painting to ensure maximium adhesion of subsequent coatings.
Typical properties and application data
||Dulux AcraTex 400/4 Tiltwash is applied using an airless spray unit (eg Graco 695 with a .0015 - .0019 tip at 1000 psi) or a low pressure knapsack spray unit. Large panels should be articulated into manageable work areas, always maintaining a wet edge ensuring rinsing of TiltWash is actioned prior to the area drying. If TiltWash dries, re-apply TiltWash to the affected area and rinse thoroughly. This will produce a foaming wave of excess material descending down the panel. As TiltWash is applied the panel should take on a darkened appearance. Should this not happen, apply a second coat of Dulux AcraTex 400/4 Tiltwash and consult with Dulux AcraTex. Rinse panel with a flood of water (heavy spray not jet) deluging panel from top to bottom. Ensure extra care is taken whilst rinsing to ledges, sills and all fixtures on panels. A second rinse should be performed whilst panel is still wet from initial rinse. This is to make sure all remnants of bondbreaker and TiltWash are removed. This product should not be released into any watercourses, drains or gutters neat or diluted and should be contained and disposed of under local waste management procedures. For full details refer to individual Duspec Product and AcraTex Applicational Data Sheets |
|Spread Rate M2 per litre per coat
||Number of coats
||1-2 subject to surface contamination
||24 months maximium
||Spread rates nominated are theoretical maximum rates
required to achieve the specified film builds for technicalperformance