DULUX AcraTex Acrasilane IBTES

Code: 194-85806

DULUX AcraTex 964 AcraSilane IBTES in a non film-forming, deep penetrating surface treatment that chemically bonds within the masonry pore structure to create a permanent hydrophibic layer on and below the surface of bare concrete and other mineral based porous surfaces. Typically used in structural grade installations where as a concrete pretreatment under AntiCarbonation Coating systems providing ultimate and last line defense against the ingress of water soluble chloride ions which other wise may accelerate re-bar corrosion.

Features

  • Repels water, Chlorides
  • Invisible film
  • Penetrates deeply into dense concrete
  • Treatment becomes part of the concrete and cannot peel

Benefits

  • Minimises dampness in porous surfaces & protects against moisture
  • No change in the appearance of masonry
  • Apply direct to bare masonry.
  • In beds itself as part of the structure

Performance Guide

Weatherability] Protects masonry for up to 3 years.
Heat Resistance] Resistant to normal exterior surface temperatures.
Water Resistance] Excellent resistance to rain and condensation for prolonged periods
Abrasion Resistance] Moderate resistance to abrasion
Solvent Resistance] Resists alcohols & hydrocarbons

Surface Preparation

Relative to Project Substrate and Specified Finish - refer to Project Specific Duspec Specification and AcraTex Substrate Guide

Bases

Clear

Use and typical specification

Use DULUX AcraTex 964 AcraSilane IBTES to reduce water and chloride absorption on unpainted concrete . DULUX AcraTex 964 AcraSilane IBTES penetrates into the pores and forms an invisible protective film. Dependant on the porosity of the substrate / specification multiple saturation coats may be required. Recommended on reinforced concrete structures such as low and high-rise buildings, wharves, concrete bridges, car parks and sound barriers.

Typical properties and application data

Application Guide DULUX AcraTex 964 AcraSilane IBTES is applied to the surface by saturation using a hand pressure spray applicator or HPLC spray equipment . The product should be applied as a stream which runs down the wall approximately 10 - 20 cm. A second application should follow 1-2 hours after the first application. The object is to saturate the surface so that the product can penetrate as far as possible into the surface. For full details refer to individual Duspec Product and AcraTex Applicational Data Sheets.
Technology Type 1>98% active Isobutyltriethoxy
Volume solids 2.0%
Number of coats 1-2 subject to concrete denisty,
WFT (Micron per coat) 0
DFT (Micron per coat) 0
Spread Rate Sqm/L Per coat 3.333
Touch Dry 1-2 hours
VOC content 390
Toxicity Lead free. Forms a non toxic film. Conforms to AS1647.3
Application Nap Roller or Spray
Clean up Clean equipment with methalayted spirits
Recoat Time (25°C,50%R.H.) 1-22 hours
Shelf Life 12 months maximium
Sizes 15 Litres
Notes Spread rates nominated are theoretical maximum rates required to achieve the specified film builds for technical performance

Product downloads

Product Data Sheet - pdfMaterial Safety Data Sheet

Related products

Top of the page