DULUX AcraTex 500/2 AcraPatch Coarse

Code: 194-20806

DULUX AcraTex 500/2 AcraPatch Coarse is an acrylic based, granular patching compound. Supplied in a water based paste requiring the addition of 5-10% cement it exhibits minimal shrinkage on drying and good adhesion to clean masonry substrates. Approved James Hardie Fibre Cement Jointing compound.

Features

  • Easy to handle
  • 100% water-based acrylic
  • Fills up to 4mm deep blemishes
  • Mixes with cement

Benefits

  • Fast, efficient application
  • Flexible, minimal shrinkage, easy clean up.
  • Gives smooth surface for textured topcoats.
  • Forms very durable exterior patching material.

Performance Guide

Weatherability] Excellent weather resistance when mixed with cement when top coated with a full Acra-Tex system.
Heat Resistance] Up to 60C.
Water Resistance] Resists rain and condensation when top coated with a full Acra-Tex system.
Abrasion Resistance] Resists abrasion when top coated with a full Acra-Tex system. .
Solvent Resistance] Sensitive to alcohols, aromatic hydrocarbons, acetone and strong solvents.
Salt Resistance] Resists salt spray when when top coated with a full Acra-Tex system.

Surface Preparation

Relative to Project Substrate and Specified Finish - refer to Project Specific Duspec Specification and AcraTex Substrate Guide

Sizes

15L

Use and typical specification

DULUX AcraPatch Coarse can be used as a base filler for filling larger surface irregularities & blemishes of up to 4mm per coat. This product can also be used as a skim coat over flush jointed blockwork prior to application of texture coatings. DULUX AcraTex 500/2 AcraPatch coarse can be applied to any clean masonry surfaces. It should be top-coated with a selected DULUX AcraTex coating system. The product is also used for the flushing of joints with the addition of 10% clean Portland cement on Fibre Cement Sheetings incorporating an alkaline resistant mesh and then as an entire skimcoat ( no cement ) over the board when the joints have dried.

Typical properties and application data

Application Guide DULUX AcraTex 500/2 AcraPatch Course Applied by Plastering Technique (Hawk and Trowel). A spatula knife can be used for isolated patching and often a sponge float is used to spread the material over extensive blow holes. Multiple coats may be needed to fill larger surface irregularities .For exterior application us a power mixing device to incorporate 10%-20% cement. For interior applications use the product as supplied. For full details refer to individual Duspec Product and AcraTex Applicational Data Sheets.
Technology Type 100% Acrylic
Volume solids 65%
Number of coats 1-2
WFT (Micron per coat) 1538
DFT (Micron per coat) 1000
Spread Rate Sqm/L Per coat 0.7
Pot Life 1 hour
Touch Dry 1 hour (At 2mm DFT)
Toxicity Lead free. Forms a non toxic film. Conforms to AS1647.3
VOC content <25g/L untinted
Application Trowel
Number of coats 1-2
Clean up Water
Recoat Time (25°C,50%R.H.) 24 hours
Full Cure (25°C,50%R.H.) 7 days
Shelf Life 12 months maximium
Sizes 15 litre
Notes Spread rates nominated are theoretical maximum rates required to achieve the specified film builds for technicalperformance

Product downloads

Product Data Sheet - pdfMaterial Safety Data Sheet

Related products

Top of the page