DULUX Ferrodor® 810 - PC552

Code: 810-LINE

Approvals: AS/NZ 3750.12; Approved to APAS 2910 over Luxaprime ZP.

Ferrodor® 810 is a single-pack alkyd enamel containing a high level of micaceous iron oxide, offering excellent durability in mild to moderate environments. Ferrodor® 810 resists UV exposure with minimum chalking.


  • Available in Natural Grey, Mid Grey and St Enoch Grey
  • Single pack, easy to use
  • Micaceous iron oxide pigmentation
  • Resistant to degradation by weathering
  • Good moisture resistance


  • Subtle metallic lustre

Performance Guide

WeatherabilityVery good long term durability on exterior exposure. Some chalking and slight colour change may occur. Metallic lustre increases over time.
Heat ResistanceUp to 120°C dry heat.
Water ResistanceExcellent resistance to fresh and salt water. Not suitable for immersion.
Abrasion ResistanceGood abrasion resistance when fully cured.
Solvent ResistanceResists splash and spillage of aliphatic and aromatic hydrocarbons and common alcohols.
Acid ResistanceSuitable for splash and spillage of mild acids. Aluminium containing colours are not suitable for acidic conditions.
Alkaline ResistanceSuitable for use in mild alkaline conditions. Aluminium containing colours are not suitable for alkaline conditions.
Salt ResistanceSuitable for splash and spillage of neutral and alkaline salt solutions. Aluminium containing colours are not suitable for acid or alkaline conditions.


Roller, Brush, Airspray, Conventional Spray

Surface Preparation

Round off all rough welds and sharp edges, and remove weld spatter. Degrease by detergent wash according to AS1627.1. For all structural and decorative steel, abrasive blast clean to AS1627.4 Class 2.5. Remove all dust. Apply first coat before surface deterioration occurs.


Ferrodor® 810 is typically used for the protection of roofs, tanks, silos and above ground pipelines and general steel in rural or mild industrial environments.


4L cans


Natural Grey, Mid Grey, St Enoch Grey

Use and typical specification

[Steel]: Power tool clean to AS1627.2 St 3. Typical system: 1 x Luxaprime® ZP @ 75 microns + 2 x Ferrodor® 810 @ 50 microns.

Product downloads

Product Data Sheet - pdfMaterial Safety Data Sheet

Related products

Top of the page
Top of the page