DULUX Luxepoxy® 4 White Primer - PC200

Code: 731-LINE

Approvals: APAS 2972F

Luxepoxy® 4 White Primer is a non inhibitive two-pack epoxy primer recommended for priming galvanized steel, aluminium or concrete. The low film build allows faster drying.


  • Single pack, easy to use
  • Easy to apply by brush, roller, conventional or airless spray
  • Good adhesion and performance on power-tool cleaned steel

Performance Guide

WeatherabilitySome chalking will occur on exterior exposure if not topcoated. This will not detract from the protective properties of the coating.
Heat ResistanceUp to 120°C dry heat.
Water ResistanceResists condensation and rain. Not suitable for permanently damp conditions or immersion.
Abrasion ResistanceGood abrasion resistance when fully cured.
Solvent ResistanceWithstands intermittent splash and spillage of aliphatic and aromatic hydrocarbons.
Acid ResistanceNot recommended where fumes, splash or spillage may occur.
Alkaline ResistanceNot recommended where fumes, splash or spillage may occur
Salt ResistanceExcellent resistance to splash ans spillage of neutral salt solutions.


Roller, Brush, Airspray, Conventional Spray

Surface Preparation

Round off all rough welds and sharp edges, and remove weld spatter. Degrease by detergent wash according to AS1627.1. For all structural and decorative steel, abrasive blast clean to AS1627.4 Class 2.5. Remove all dust. Apply first coat before surface deterioration occurs.


Luxepoxy® 4 White Primer is typically used as a primer under suitable topcoats on cranes, tanks and roofs,and as a primer/finish in internal steelwork in warehouses and factories.


4L and 15L cans

Use and typical specification

[Steel]: Power tool clean to AS1627.2 St 3. Typical system: 1 x Luxaprime® ZP @ 75 microns + 2 x Duraflex® 2 @ 50 microns.

Product downloads

Product Data Sheet - pdfMaterial Safety Data Sheet

Related products

Top of the page
Top of the page